How to Use a Bubbler: Hammer, Mini and Joint Bubblers Step by Step
· 8 min read

A bubbler is a hand pipe with a small water chamber built in. It's easier to carry than a bong and smoother than a dry pipe, but the first time you pick one up it isn't always obvious where the water goes, what the little hole on the side is for, or how to empty it without a mess. This guide covers how to use a bubbler step by step, how the main styles differ (hammer, spoon hybrid, mini bowl bubblers and joint bubblers), the mistakes that cause splashback, and how to keep one clean. It ends with what to know if you're ordering a bubbler from the UK, Germany, Italy or elsewhere in Europe.
If you're still deciding between a bubbler and a bong, read our bubbler vs bong comparison first. This post is about using one.
The parts of a bubbler
- Bowl: the shallow dish you pack. On most bubblers it's part of the glass and doesn't come out.
- Stem: a short tube inside the piece that carries smoke from the bowl down into the water. Some have small slits at the end (a diffused stem) to break the smoke into smaller bubbles.
- Water chamber: the small reservoir, usually at the bottom or front of the piece.
- Carb: a small hole, usually on the side of the bowl area. You cover it with a finger while you draw and uncover it to clear the smoke.
- Mouthpiece: the opening you breathe through. On most bubblers it's also where you add the water.
Not every bubbler has a carb. Pieces with a removable bowl, like the Hemper 6" Snail Bubbler Bong, are cleared by lifting the bowl out instead, like a bong.
How to use a bubbler, step by step
1. Add water through the mouthpiece
Hold the bubbler upright and pour a small amount of cool water into the mouthpiece. A small funnel, a squeeze bottle or a careful pour from a glass all work. You want the end of the stem just covered, often only a few millimetres. Bubblers hold far less water than bongs, so add a little at a time.
2. Test the pull
Before packing anything, cover the carb and take a gentle breath through the mouthpiece. You should hear bubbling and nothing should reach your mouth. If water comes up, tip some out. If there's no bubbling at all, add a few drops more.
3. Pack the bowl
Grind your herb to a medium consistency (our how to use a grinder guide explains grind size) and fill the bowl loosely, then press it down lightly so the top is level. A bowl packed too tight is hard to pull through; too loose and pieces get pulled into the stem. Our how to pack a bowl guide goes into more detail.
4. Light and draw slowly
Cover the carb with a finger, hold a flame just above the edge of the bowl and draw slowly so it pulls down into the herb. Don't bury the flame in the bowl. Light only one edge of the bowl ("cornering") if you want to save the rest for later.
5. Clear the chamber
When the chamber has filled, take your finger off the carb (or lift out the bowl on a removable-bowl piece) and finish the breath to pull the remaining smoke through. Because the chamber is small, this takes much less effort than clearing a bong.
6. Empty and rinse after the session
Turn the bubbler upside down over a sink and let the water run out of the mouthpiece. Some pieces empty faster if you blow gently through the bowl end. Rinse with warm (not hot) water and let it drain upright. Don't leave old water sitting in it overnight: it starts to smell and residue sets harder.
Using different types of bubbler
Hammer bubblers
A hammer bubbler has a flat-bottomed chamber that lets it stand on its own, with the mouthpiece angled off one end. The Glass Hammer Bubbler 6" has a small chamber and a diffused stem. Fill through the mouthpiece with the piece standing on its base, check the water just covers the stem, and use the carb as above. Set it down on its base between hits, not on its side.
Spoon and bubbler hybrids
These look like a spoon pipe with a water chamber built into the body. On the Daze Glass Spoon & Bubbler Hybrid you pour water in through the mouthpiece until it bubbles when you draw. Its chamber is designed to resist splashing and leaking when it's laid on its side, but it still helps to empty it before you put it in a bag.
Bubblers with a removable bowl
Small "bubbler bongs" such as the Hemper Snail use a separate 14 mm bowl and a perc. Fill to just above the perc slits, pack the removable bowl, and clear by lifting the bowl out. If you need a spare, check the joint size against our smoking accessory size chart first.
Joint and blunt bubblers
A joint bubbler doesn't have a bowl at all. You fit the end of a lit joint or blunt into its opening, and the smoke is pulled through water on the way to your mouth. On the MJ Arsenal Martian, add a little water, push the joint in snugly, cover the carb while you draw and release it to clear. If you roll your own, our how to roll a cone and how to roll a joint guides help you get a size that fits.
Common bubbler problems and fixes
| Problem | Likely cause | Fix |
|---|---|---|
| Water in your mouth | Too much water, or pulling too hard | Tip some water out and draw more gently |
| No bubbling | Water below the stem | Add water a few drops at a time |
| Hard to pull | Bowl packed too tight, or a blocked stem | Repack loosely; clear the stem with a pipe cleaner |
| Smoke stays in the chamber | Carb still covered | Release the carb (or lift the bowl) to clear |
| Harsh, stale taste | Old water or a dirty chamber | Change the water every session and clean weekly |
| Bits of herb in the water | Grind too fine for the bowl | Use a coarser grind or a glass screen if it fits |
How to clean a bubbler
Because the water chamber is sealed into the glass, you clean the whole piece in one go:
- Empty the water and rinse with warm water.
- Add isopropyl alcohol and a spoonful of coarse salt through the mouthpiece, or use a ready-made cleaner such as Formula 420 Original Glass Cleaner.
- Cover the openings (fingers, silicone plugs or a bit of cling film) and shake gently so the salt scrubs the inside.
- Run pipe cleaners through the carb, stem and mouthpiece.
- Rinse thoroughly with warm water until no alcohol smell remains, and let it dry fully before the next use.
Avoid pouring very hot or boiling water into cold glass: sudden temperature changes can crack it. Our full cleaning guide for glass pipes and bongs covers soaks for heavier build-up, and our glass storage guide covers keeping a bubbler safe between sessions.
Ordering a bubbler from the UK, Germany, Italy or the EU
Bubblers, glass pipes and other accessories ship from us to the United Kingdom and every EU country, including Germany and Italy. Before you order:
- Shipping is a flat $300 USD per order to the UK or any EU country, however many accessories are in the cart. It's added at checkout, so you see the full total before you pay. Product prices don't include it.
- Every order needs at least $150 of items, counted before discounts and shipping. A small bubbler on its own may not reach that, so many buyers add a grinder, cleaner or rolling gear.
- UK orders need more than £135 of items, after any discount and not counting shipping. Checkout converts the item total from US dollars to pounds and won't accept a smaller UK order.
- We don't collect UK VAT or EU import VAT at checkout. On UK orders, import VAT and any duty are collected by the courier from you on delivery. EU orders may have VAT, import duty or courier fees to pay on delivery.
- Only accessories ship to the UK and EU. Hemp and other cannabinoid products ship to eligible US addresses only.
Rules on smoking accessories differ by country, and Europe isn't one market, so check the rules where you live. Our are bongs legal? guide covers the UK and Germany, and the international shipping page has the full details. Browse bubblers and hand pipes on our pipes page.
FAQ
How much water do you put in a bubbler?
Just enough to cover the end of the stem inside the chamber, which on most bubblers is only a few millimetres. Add it through the mouthpiece a little at a time and test the pull before packing.
What is the carb on a bubbler for?
The carb is a small hole near the bowl. You cover it while you draw so smoke fills the chamber, then uncover it to let air in and clear the remaining smoke in one breath.
How do you use a bubbler without a carb?
If the bowl is removable, lift it out to clear the chamber, the same way you would on a bong. If the piece has no carb and a fixed bowl, just keep drawing steadily until the chamber is empty.
How do you use a joint bubbler?
Add a little water, fit the end of a lit joint or blunt snugly into the opening, cover the carb while you draw and release it to clear. The smoke passes through the water before it reaches you.
Do you ship bubblers to the UK, Germany and Italy?
Yes. Bubblers and other accessories ship to the UK and all EU countries, including Germany and Italy, for a flat $300 USD per order, added at checkout. Every order needs at least $150 of items, and UK orders need more than £135 of items, excluding shipping.
Adults 21+. Accessories are sold for legal use with tobacco or legal herbs. A bubbler doesn't make smoking safe. Local laws on accessories differ by country; check yours before ordering.
— The Shop Kushina Team
Ready to order?
Browse the full menu or THCA flower. Questions? Call or text (507) 323-2528.
More guides
Follow Shop Kushina on Google